![]() it doesn't do that if I'm in dry run mode. Our Leapfrog Creatr goes through the usual start-of-job moves, proceeds to the location where it would start extruding the skirt, and then comes quietly to a halt.ĮXCEPT. I'm using Firmware 0.82, freshly downloaded, which appears to have the DTR-ignore function pre-set. OK, I just developed what seems like this same problem. The following is repeated many times at the end of the log, looks like the command has the wrong checksum and it never recovers.Ģ:32:59 PM: N2723 G1 X21.11 Y5.32 E135.3127 *113 The GCODE can be found in this forum post for inspection: I don't know how many lines there would be without empty and comment lines. However, this is GCODE including comment lines. This doesn't ring a bell concerning stack overflow due to max variable ranges. The 90th layer starts on line 897'944 in the code. The only explanation which remains is, that it could be some stack overflow problem. There are only FAN on/off, G1 positioning, extruding, retracting and motor speed setting commands, next to " " comment lines. Looking at the GCODE, I cannot find any strange commands either. The PC was off anyway, so there is no possibility, that there was a faulty code sent over USB. The last print was from the SD card, so the USB definitely didn't cause this. All three prints aborted during layer 90. Three of them are from the same KISSLICER GCode. On the other side, the firmware stops moving the motors, shows idle, keeps the temperatures set and responds to any command through the LCD controller input. So, the host stays in print mode and keeps counting the time till print end. The host sends the last GCODE lines and waits for the firmware to request the next lines, which never happens. ![]() However, I checked the last lines of the communication protocol and there is nothing unusual. Unfortunately, this only worked after restart of the host. Ok, last time when printing from the PC, I activated the log.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |